Author Topic: Equipment Dilemma - Williams & Hussey Molder  (Read 2393 times)

0 Members and 1 Guest are viewing this topic.

Offline Doug Anders

  • Posts: 29
Equipment Dilemma - Williams & Hussey Molder
« on: April 17, 2008, 02:03 PM »
I was given an older (but in EXCELLENT) condition Williams & Hussy Molder (power in-out feed) by a friend. It is wired up with a 1 hp moter for 110 volt use.

The thing is pretty cool and I but I'm not sure if I'll ever get much use out of it. I'm inclined to sell it on ebay so that I can buy more Festools or a HVLP spray system, but am wondering if that's too short sighted of me...

I definitely would use the HVLP frequently and would definitely like to get the new Festool trim router.

What do you think?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline greg mann

  • Posts: 1836
Re: Equipment Dilemma - Williams & Hussey Molder
« Reply #1 on: April 17, 2008, 02:42 PM »
You have nothing into it so you can't lose either way, except you might hurt a friend's feelings. Unless you have already discussed the possibility of it moving on.
Greg Mann
Oakland, Michigan

Offline Scott W.

  • Posts: 333
Re: Equipment Dilemma - Williams & Hussey Molder
« Reply #2 on: April 17, 2008, 07:31 PM »
I was given an older (but in EXCELLENT) condition Williams & Hussy Molder (power in-out feed) by a friend. It is wired up with a 1 hp moter for 110 volt use.

The thing is pretty cool and I but I'm not sure if I'll ever get much use out of it. I'm inclined to sell it on ebay so that I can buy more Festools or a HVLP spray system, but am wondering if that's too short sighted of me...

I definitely would use the HVLP frequently and would definitely like to get the new Festool trim router.

What do you think?

They work great as a  little planer also.

Scott W.
PA, USA