Author Topic: Felder AD941  (Read 4536 times)

0 Members and 1 Guest are viewing this topic.

Offline jcalberto

  • Posts: 4
Re: Felder AD941
« Reply #30 on: September 12, 2017, 12:52 PM »
Hi Guys,

I just placed an order to the same AD941 and will get delivery until end of December.  One question I have is regarding any additional upgrades or options you all might of added.  I am still able to make some changes and I am not debating if I should get the 3phase option or stick with the 4hp single phase?

Thanks,
Albert

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline egmiii

  • Posts: 55
Re: Felder AD941
« Reply #31 on: September 12, 2017, 12:56 PM »
I hope you ordered it with power drive, spiral cutter block, and comfort guard. If so, the single phase motor has plenty of power. Going out on a limb here, but I'd assume the single phase would also have higher resale value since most hobbyists don't have 3 phase power.

Offline jcalberto

  • Posts: 4
Re: Felder AD941
« Reply #32 on: September 12, 2017, 03:03 PM »
Thanks for the feedback.  You make a great point of keeping single phase for higher resale.  Regarding the other options, they were all standard on my 941 order.   

Offline Llama

  • Posts: 29
Re: Felder AD941
« Reply #33 on: September 12, 2017, 05:52 PM »
The only thing I'd want to add to my AD941 is a power feeder. :) It will be mine!

Offline egmiii

  • Posts: 55
Re: Felder AD941
« Reply #34 on: September 12, 2017, 08:04 PM »
The only thing I'd want to add to my AD941 is a power feeder. :) It will be mine!

I've only had mine up and running for just over a week, and I think I started researching power feeders the second night. You just can't beat the finish and safety aspects.