Author Topic: Felder K700 or K500 tablesaw question  (Read 1356 times)

0 Members and 1 Guest are viewing this topic.

Offline 9Fingers

  • Posts: 38
Felder K700 or K500 tablesaw question
« on: May 04, 2018, 10:56 AM »
Hi, I have a Felder K500 saw and am looking for some help to adjust the travel of the sliding table. It is about 7-10 thousandths off and the work pieces are contacting the rear of the blade as they are pushed by. I bought this saw used and suspect the table was moved slightly in transit. I have the user manual from Felder but it doesen't cover that adjustment
Any help is appreciated, thanks.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Sparktrician

  • Posts: 3591
Re: Felder K700 or K500 tablesaw question
« Reply #1 on: May 04, 2018, 11:59 AM »
You can always contact Felder Tech Support.   [smile]
- Willy -

 "Remember, a chip on the shoulder is a sure sign of wood higher up." - Brigham Young

Offline egmiii

  • Posts: 92
Re: Felder K700 or K500 tablesaw question
« Reply #2 on: May 04, 2018, 01:18 PM »
Sign up for the Yahoo Felder Owner Group and repost. It's an archaic format, but you will get a solid answer likely within the hour. I'd add a few more details about the machine and the specifics about how you are making the cut.

Offline lwoirhaye

  • Posts: 148
Re: Felder K700 or K500 tablesaw question
« Reply #3 on: May 04, 2018, 04:23 PM »
You might want to check to see if the blade is heeling first.  That would be an easier adjustment. 

I have a Felder and the blade is heeling a little.  It didn't when I got it but I've moved it around a lot on a pallet jack and I think it may have drifted a little.  It's heeling on the rip side though so it's a less pressing concern to me, which is why I haven't got around to adjusting it.