Author Topic: Fitting the Trion Guide Stop on the Bosch 1591 baseplate  (Read 1559 times)

0 Members and 1 Guest are viewing this topic.

Offline Sean G

  • Posts: 58
Hello, I recently purchased the Bosch 1591 jigsaw and its dust collector attachment (try as I might, I couldn't justify  the extra $$$ for the Trion). It's a fantastic tool. Although I was able to try the 1591 at the shop where I bought it, I've never handled the Trion. Can anyone who owns or has used both tell me if there is any way I could fit the Trion's guide stop accessory on the base plate of the 1591? I primarily use the jigsaw for curved cuts, and I know that the back side of a Festool guide rail would serve as a reasonable alternative if and when needed, but I was just wondering.


« Last Edit: March 24, 2009, 09:57 AM by Sean G »
Two things fill the mind with ever-increasing awe - the starry heavens above me and the moral law within me.

- Immanuel Kant

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.