Author Topic: Hammer F3 Micro Adjust Fence  (Read 621 times)

0 Members and 1 Guest are viewing this topic.

Offline mbrusso

  • Posts: 16
Hammer F3 Micro Adjust Fence
« on: March 12, 2017, 10:26 AM »
Hi
I am JUST getting started with tuning my F3 shaper and wanted to ask if anyone with the micro adjust is finding the same experience.

I am noticing that the left fence (looking directly at the machine) has somewhat of a "skew" in the fence.

Upon putting my stabila level which also is a good straight edge on the front face of the micro adjust without the fences it appears both sides of the fence mount faces are skewed like this (seen by a gap on the right whereas the level touches on the left)

I am new to the world of shapers so maybe this is how this is setup, but if I want to setup my fences square, it requires set screw adjustment to compensate for this.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.