Author Topic: HELP!! I need to Mortis 3" deep with with 5/16" on drill press... Any leads???  (Read 846 times)

0 Members and 1 Guest are viewing this topic.

Offline Handle1

  • Posts: 1
Help!!!! I am striking out on this!!! all mortis augers seem to only reach 1.75" deep; but i am in need of going 2.5-3" deep into a  1" handle I am center boring with a 5/16 mortising set up on my drill press... Any leads would be greatly appreciated!!!!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline derekcohen

  • Posts: 284
    • In The Woodshop
Mark the mortice on both sides of the stretcher, and drill out half way from each side.

Regards from Perth