Author Topic: New lathe extension  (Read 2270 times)

0 Members and 1 Guest are viewing this topic.

Offline Peter Teubel

  • Posts: 148
New lathe extension
« on: May 29, 2008, 11:03 PM »
After doing a job for a couple 8ft porch columns (had to do them as two-piece turnings), I decided to upgrade my lathe to handle these type of jobs as ONE piece. With the new 60" extension plus the small 17" extension, I now have the ability to turn 113" between centers. It will make future jobs go alot faster (and therefore more profitable).


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Scott W.

  • Posts: 333
Re: New lathe extension
« Reply #1 on: May 29, 2008, 11:10 PM »
Now THAT IS A LATHE! :) :) :)

Scott W.
PA, USA

Offline Steve-CO

  • Posts: 787
Re: New lathe extension
« Reply #2 on: May 29, 2008, 11:30 PM »
When's your 1st 8 ft segmented turning scheduled, now that would be something to see.

Offline tvgordon

  • Posts: 501
  • Springfield, Ohio
Re: New lathe extension
« Reply #3 on: May 30, 2008, 05:16 PM »
Wow, Oneway - nice! ;D ;D

Tom.