Author Topic: Shaper Origin Feedback ?  (Read 6742 times)

0 Members and 1 Guest are viewing this topic.

Offline papester

  • Posts: 8
Re: Shaper Origin Feedback ?
« Reply #30 on: January 26, 2019, 11:19 AM »
You'll probably find for scanning it might not draw enough power to trigger the vac.  Turning on the motor though, that should trigger it.
That is correct. The vacuum will only turn on when the spindle is powered on, the Origin will be functional with the vacuum in Auto mode.


Sent from my iPad using Tapatalk

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.