Author Topic: Step Clamps  (Read 455 times)

0 Members and 1 Guest are viewing this topic.

Offline suds

  • Posts: 351
Step Clamps
« on: April 18, 2017, 11:54 PM »
Wondered if any of you fellas use step clamps and how it's worked for you?  Seems like it could work on a MFT table as well as drill press etc.
MFT's, Kapex, TS 55, Vac, 150 Rotrex, 300 Trion, Domino

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Bob D.

  • Posts: 186
Re: Step Clamps
« Reply #1 on: April 20, 2017, 08:00 PM »
Not really sure what you mean by step clamps.

I have some step blocks that I use when clamping tall items to my DP table.
They are in 1/2 inch increments. from 1/2 up to 2-1/2 inches and made
from some scraps of red oak about 2 inches wide.
It's a table saw, do you know where your fingers are?