Author Topic: 3/4” Walnut Edge Banding - Finish or Glue First?  (Read 1515 times)

0 Members and 1 Guest are viewing this topic.

Offline Bugsysiegals

  • Posts: 86
3/4” Walnut Edge Banding - Finish or Glue First?
« on: March 10, 2018, 10:02 PM »
I’m building a mobile cart for my Festool systainers which will use 3/4” prefinished Maple veneer plywood. I decided to add 3/4” Walnut around the edges to give it some contrast and better support for drawer glide screws.

As the topic states, should I glue the Walnut to the plywood shelves and then mask things off to finish it or finish the Walnut and then glue it to the plywood?  If the later, do I put painters tape on the edge I’ll glue to keep it clean or just spray the clear from the top and the bottom won’t get enough on it to stop it from gluing well?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tjbnwi

  • Posts: 5620
  • Cedar Tucky Indiana
Re: 3/4” Walnut Edge Banding - Finish or Glue First?
« Reply #1 on: March 10, 2018, 11:10 PM »
Either way will work well. Pick which ever works easiest for you.

Keep the finish off the edges to be glued.

Tom

Offline lwoirhaye

  • Posts: 148
Re: 3/4” Walnut Edge Banding - Finish or Glue First?
« Reply #2 on: April 20, 2018, 12:37 PM »
It's a trick to line it up perfectly flush and plywood varies a little in thickness anyway.  Most woodworkers glue it on thicker and trim off the excess.  There will also be a glue squeeze out line the trimming cut removes.