Author Topic: Attaching wood inlay to a gold ring  (Read 816 times)

0 Members and 1 Guest are viewing this topic.

Offline Aclaw

  • Posts: 72
Attaching wood inlay to a gold ring
« on: February 10, 2016, 09:56 AM »
Fellow Foggers,

I am creating my wedding band and am incorporating a wooden element into the center channel of the ring after casting as you can see in the photos below.  The channel is not deep and is separated by the screws that will hold the ring together past the knuckle (because of a broken knuckle).  Because of both the separation in the channel, and the minimal depth, I believe I can use a veneer to complete the ring to my liking. 

Question is what would be the suggestions for securing the veneer to the white gold and encasing it via and epoxy or something to the like that can be polished and hold up to almost daily wear, at least when I'm not in the shop. [tongue]

Thanks for any suggestions,

AC



 

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.