Author Topic: Cabinet door/drawer program?  (Read 2811 times)

0 Members and 1 Guest are viewing this topic.

Offline tjbier

  • Posts: 324
Cabinet door/drawer program?
« on: November 30, 2017, 04:53 PM »
  What do you do for cabinet data entry? What I mean is, is there a program to enter the width and height of a door or drawer opening and it will auto fill all the info that has been setup in the system ( inset, overlay, tenon size,  drawer widths/heights, drawer fronts ect.). Then it will give a cut list for stile length, rail length ( with whatever size tenon is entered added to the cut) , and the panel size that goes with that door.
  Or do you do all the math to figure everything out?
« Last Edit: November 30, 2017, 07:44 PM by tjbier »
Tom- ps, I read these.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline tjbnwi

  • Posts: 5591
  • Cedar Tucky Indiana
Re: Cabinet door/drawer program?
« Reply #1 on: November 30, 2017, 06:26 PM »
I use Cabinet Vision for multiples, doing in my head for singles.

Tom

Offline Oldwood

  • Posts: 326
  • Alberta, Canada
Re: Cabinet door/drawer program?
« Reply #2 on: November 30, 2017, 08:05 PM »
A spread sheet works pretty well for that. Most of the cabinet programs have a fairly steep learning curve, which is fine if you are doing a lot or output to CNC. We use E cabinets from Thermwood it is a free download and will do what you want but you need to invest a LOT of time into learning it. It will only produce code for Thermwood routers but will give you straight line cut lists if you cut with a table saw.
 
If you would like a sample spread sheet send me a PM and I will send you one we used to do all the cabinets and doors in a kitchen that you can use as a jumping off point.
Real knowledge is to know the extent of one's ignorance.
Confucius

Offline 7sec153

  • Posts: 18
Re: Cabinet door/drawer program?
« Reply #3 on: November 30, 2017, 08:21 PM »
Send me your dimensions I’ll do a cut list for you.