Author Topic: Rule of Thumb for width of Mirror Moulding  (Read 1966 times)

0 Members and 1 Guest are viewing this topic.

Offline jar45

  • Posts: 34
Rule of Thumb for width of Mirror Moulding
« on: March 18, 2017, 11:58 AM »
I wish to make an oak frame for a 16.5"x 27.5" x 0.125" mirror.  The mirror was salvaged for an old medicine cabinet.  Which is the reason for the odd size.

Any rule of thumb for the ratio of the moulding width to the area of the mirror or picture?   I was planning on using 2" wide x 3/4"  qtr saw oak and 6 mm domions on the corners.     I have had some good success using my Domino 700 to secure mitered corners.
 
My request is mainly curiosity.
 
Thanks
John

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline neilc

  • Posts: 2161
Re: Rule of Thumb for width of Mirror Moulding
« Reply #1 on: March 18, 2017, 04:32 PM »
Here's some general guidelines for picture framing.  Short answer - largely personal taste with some general ratios around mats, frames and artwork. 

https://www.usaoncanvas.com/include/guide_proportion_picture_frames.php

In your case 2" is probably OK.  With a mirror, I also think it depends on what it is hanging over.  If I was hanging that mirror horizontally, I might go to 4" or larger and have it look fine.  The general trend in today's style has been larger frames relative to the piece being framed.

You might look on Pinterest or Houzz for inspiration around size.



Offline jar45

  • Posts: 34
Re: Rule of Thumb for width of Mirror Moulding
« Reply #2 on: March 18, 2017, 04:57 PM »

Thank you.     

I saved the site as a favorite.

John

Offline mrFinpgh

  • Posts: 228
Re: Rule of Thumb for width of Mirror Moulding
« Reply #3 on: March 18, 2017, 11:00 PM »
@neilc has a good idea to look at picture framing for a sense of scale an proportion.

I recently made a frame for a mirror inspired by Aksel Kjersgaard and it was about 2" at the widest points, coming in about 3/8 of an inch on a curve.   That mirror is on a wall adjacent to a mirror with a frame that is about 10" wide.

Much will depend on the aesthetic that you're after and where you plan on locating it.

Offline jar45

  • Posts: 34
Re: Rule of Thumb for width of Mirror Moulding
« Reply #4 on: March 23, 2017, 05:29 PM »
Thanks.

I'm looking to match  the design of a medicine cabinet, vanity and a wall shelf I made.   So, it will basically be 4 sides of the same width. 

I used French cleats to hang the cabinet and shelf and hope to do the same for the mirror.

Thank you,

John