Author Topic: Veneer thickness question for inlay  (Read 576 times)

0 Members and 1 Guest are viewing this topic.

Offline atogrf1

  • Posts: 142
  • FESTOOL
Veneer thickness question for inlay
« on: March 07, 2015, 11:06 AM »
I hope this post is in the right place.
I recently purchased the Robert Millard video about making the oval fan inlay for Federal furnitute.  It was VERY informative and I am going to attempt it for my next piece.
However, does anyone know if the veneer he uses in it is the 1/25 or 1/42 thickness?
I don't want to use the wrong one and then have problems using the methods he teaches.
Any help would be appreciated.

Thanks!!!!

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.