Author Topic: Wood movement and pin nailers  (Read 776 times)

0 Members and 1 Guest are viewing this topic.

Offline mcooley

  • Posts: 174
Wood movement and pin nailers
« on: February 09, 2016, 03:50 PM »
Curious what people's thoughts are on bringing in a very fine seam (paper width) on a small loose tenon breadboard end? Would a single 23 gauge pin allow for enough movement of the breadboard ends?   

Thanks

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 10874
  • Let's Redux / Revive / Rewind / Rollback the FOG!
Re: Wood movement and pin nailers
« Reply #1 on: February 09, 2016, 06:16 PM »
A pin installed by a pin nailer is not that much different than the diameter of a common staple leg.  If you want it to move it will.  If you are looking for re-enforcement it won't.

Peter
Disclaimer:  I have been involved with the development of some TSO Products.  I have offered thoughts and ideas freely.  I am not paid but I may receive products during the development process or afterwards.