Author Topic: Sheet good handling  (Read 2685 times)

0 Members and 1 Guest are viewing this topic.

Offline Mario Turcot

  • Posts: 510
Re: Sheet good handling
« Reply #30 on: August 30, 2018, 11:25 PM »
You are insecure and went berserk on the plywood? or you just want to be busy for the long weekend  [eek]
Mario
Start my Festool adventure buying the DF 500 & CT-26
Following by the TS-55 with FS-1400 LR32 & ETC EC 125
Pulled the trigger on the OF 1400 and the LR32 system
Need a longer rail FS-1900 & RO 90
and finally the KS-120

Online tjbnwi

  • Posts: 5682
  • Cedar Tucky Indiana
Re: Sheet good handling
« Reply #31 on: August 30, 2018, 11:34 PM »
You are insecure and went berserk on the plywood? or you just want to be busy for the long weekend  [eek]

I order 3 or 4 bunks at a time.  Normally last 3 to 4 weeks.

Solids (hard and soft maple) I buy in increments of 500 board feet, unless it happens to be a one off. Then I order what I need plus 15%.

Blum drawer slides I order by the pallet. The last two house used just under 300 drawer slide pairs. House we’re doing now will use 278 pairs of drawer slides.

Hinges and back plates 1000 at a time, edge banding by the mile (speaking of which I need to order 10 more rolls).

Finish is ordered 25-50 gallons per order.

Tom

Offline Mario Turcot

  • Posts: 510
Re: Sheet good handling
« Reply #32 on: August 30, 2018, 11:40 PM »
wow  [scared]
Mario
Start my Festool adventure buying the DF 500 & CT-26
Following by the TS-55 with FS-1400 LR32 & ETC EC 125
Pulled the trigger on the OF 1400 and the LR32 system
Need a longer rail FS-1900 & RO 90
and finally the KS-120

Offline waho6o9

  • Posts: 1364
    • Garage Door Handyman.com
Re: Sheet good handling
« Reply #33 on: August 31, 2018, 08:49 AM »
Impressive 

Offline awil66

  • Posts: 144
Re: Sheet good handling
« Reply #34 on: August 31, 2018, 09:07 PM »
Was that a mic drop by Tom!?!?i think it was !

Offline IndyMike

  • Posts: 112
Re: Sheet good handling
« Reply #35 on: September 01, 2018, 01:33 PM »
I had a dream that I was handling sheet goods - and that I had some cool multi-use system that not only handled sheet goods but helped me with like 8 other things........ I think it was too good to be true [i.e. I don't think it was physically actually possible]...

When you start dreaming about plywood :P.
Mike