Author Topic: shop festool cabinets  (Read 4092 times)

0 Members and 1 Guest are viewing this topic.

Offline lambeater

  • Posts: 479
shop festool cabinets
« on: January 16, 2018, 08:12 AM »
Just built these for my Festool systainers and to reorganize a little. Took my last 2 sheets of prefinished ply and some scrap. Also drilled all the shelf pin holes with my 32 system so I can start installing some pull outs.



[ Specified attachment is not available ]



Lambeater.



« Last Edit: January 16, 2018, 09:03 AM by Peter Halle »

Offline Mario Turcot

  • Posts: 607
Re: shop festool cabinets
« Reply #1 on: January 16, 2018, 08:19 AM »
Would fit perfectly in my shop :)

Well done!
Mario

Offline lambeater

  • Posts: 479
Re: shop festool cabinets
« Reply #2 on: January 16, 2018, 08:21 AM »
thanks wish the images would stop rotating.

Lambeater

Offline Peter Halle

  • Global Moderator
  • *
  • Posts: 11600
Re: shop festool cabinets
« Reply #3 on: January 16, 2018, 09:00 AM »
thanks wish the images would stop rotating.

Lambeater

Fixed.

Peter

« Last Edit: January 16, 2018, 09:04 AM by Peter Halle »

Offline Stoli

  • Posts: 354
Re: shop festool cabinets
« Reply #4 on: January 16, 2018, 09:59 AM »
You'll certainly want to install the pullouts.  The tool you want next is always going to be at the bottom of a stack.
DF500; OF1400; ETS125; CXS; installer Kit;  Kapex

Offline lambeater

  • Posts: 479
Re: shop festool cabinets
« Reply #5 on: January 16, 2018, 10:52 AM »
thanks Peter

Offline lambeater

  • Posts: 479
Re: shop festool cabinets
« Reply #6 on: January 16, 2018, 10:54 AM »
You'll certainly want to install the pullouts.  The tool you want next is always going to be at the bottom of a stack.
yes I will, already drilled for them.
lambeater

Offline egmiii

  • Posts: 111
Re: shop festool cabinets
« Reply #7 on: January 16, 2018, 11:08 AM »
Curious why you put them so high. If you put the cabinet on the ground, then used SYS-AZ drawers, you could remove a tool without removing the systainer. I feel like I'm missing something.

Offline lambeater

  • Posts: 479
Re: shop festool cabinets
« Reply #8 on: January 16, 2018, 11:16 AM »
Curious why you put them so high. If you put the cabinet on the ground, then used SYS-AZ drawers, you could remove a tool without removing the systainer. I feel like I'm missing something.
yes I put them high because my shop is only 12ft wide in the main part so needed to utilize space and still be able to use table saw. seemed the best option.

Lambeater

Offline Ves

  • Posts: 35
Re: shop festool cabinets
« Reply #9 on: April 01, 2018, 12:58 PM »
Looks great. Nice apron