Having trouble with your Festool power tool? Well, we're here to help you. Before posting to the forum, give us a chance to diagnose and resolve your issue. In the U.S. and Canada, call us toll-free at 888-337-8600 on Monday-Friday between 8a-5p EST or contact us via email at service@festoolusa.com. For other countries, please visit http://www.festool.com for contact information for your local Festool service department.

Author Topic: Stuck BF-FX chuck on my CXS drill  (Read 1579 times)

0 Members and 1 Guest are viewing this topic.

Offline mikemoss

  • Posts: 1
Stuck BF-FX chuck on my CXS drill
« on: June 10, 2019, 12:33 PM »
I feel silly posting this but I have the chuck mounted on the angle attachment. No issue removing the angle attachment from the drill. However, I have tried multiple times to remove the chuck from the angle attachment but it seems stuck. I pull the release ring forwards and have tried then rotating the chuck, wondering if there is a particular point when the engaging mechanism will align and the chuck will slip free. No such luck. Am I doing something wrong? Would be grateful for some advice.
PS I love, love this drill. It's my favourite Festool product after Kapex.

Thanks, Mike Moss

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Birdhunter

  • Posts: 2681
  • Woodworker, Sportsman, Retired
Re: Stuck BF-FX chuck on my CXS drill
« Reply #1 on: June 10, 2019, 02:51 PM »
I’ve had the same issue with both my TSX and CSX. I got it loose by a combination of tugging, rotating, and rocking the chuck simultaneously. Hope this works for you.
Birdhunter

Offline HandyDen

  • Posts: 12
Re: Stuck BF-FX chuck on my CXS drill
« Reply #2 on: June 10, 2019, 09:18 PM »
I’ve had this happen between the chuck and the cxs “nose”(?).  When I got it off, I noticed it was then difficult to put the chuck back on.  Instead of sliding on smoothly like when it was new, it seemed to bind. 

I brought it to my local Festool rep, and they said a tiny burr had developed on the drill nose.  It was so small that I couldn’t see it, but I could barely feel it.  I wrapped a small piece of wet/dry sandpaper around the nose, turned the drill on for second, and it was like new again.  The sandpaper took the burr off, but didn’t even start scratching the paint.

Hope your solution is this easy!