Author Topic: Drill Holder for front of Systainer  (Read 2682 times)

0 Members and 1 Guest are viewing this topic.

Offline badtoytrd

  • Posts: 16
Drill Holder for front of Systainer
« on: April 07, 2019, 11:17 PM »
I am going to start my DIY sys cart build but while I work on a few other projects I wanted to design a drill/impact driver holder to fit in the label slot of the systainer. I designed one up for my M12 Impact and it works perfectly. Its a bit clunky but I kinda had to have as much support as possible as the slot is somewhat thin. I will be posting the design up in Thingiverse for those of you who have a 3D printer. I will also be working on a design to hold my M12 drill for the other side.

Offline DashZero

  • Posts: 100
Re: Drill Holder for front of Systainer
« Reply #1 on: April 08, 2019, 12:38 AM »
I recognize those labels  ;)

Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8956
  • Finger Lakes Region, NY State , USA
Re: Drill Holder for front of Systainer
« Reply #2 on: April 08, 2019, 11:03 AM »
That's a cool idea.  Those without a 3D printer might be able to use the  Adapt-L as a starting point to build this type of holder.  Or other holders. It would take care of the slot mount portion.

Seth


Offline Systainer.Store

  • Retailer
  • *
  • Posts: 132
    • systainer.store
Re: Drill Holder for front of Systainer
« Reply #3 on: April 08, 2019, 11:56 AM »
Did you print this in PLA, ABS, PETG or something more exotic? 

I've been thinking I need to take a weekend and do some projects like this.  First I need to get the 3D printer back in operational state.

Offline badtoytrd

  • Posts: 16
Re: Drill Holder for front of Systainer
« Reply #4 on: April 08, 2019, 12:13 PM »
Did you print this in PLA, ABS, PETG or something more exotic? 

I've been thinking I need to take a weekend and do some projects like this.  First I need to get the 3D printer back in operational state.

The one in the picture is PLA. It was a prototype. After trying it PLA is probably sufficient because of its mass but ABS or PETG would probably be ideal. I am going to try and modify it a bit to be less clunky and not use so much filament.

Offline badtoytrd

  • Posts: 16
Re: Drill Holder for front of Systainer
« Reply #5 on: April 08, 2019, 12:14 PM »
I recognize those labels  ;)

Yep and they look awesome!

Offline mike_aa

  • Posts: 1084
Re: Drill Holder for front of Systainer
« Reply #6 on: April 08, 2019, 02:01 PM »
That's a cool idea.  Those without a 3D printer might be able to use the  Adapt-L as a starting point to build this type of holder.  Or other holders. It would take care of the slot mount portion.

Seth

Another route for those of us who are without a 3D printer is checking with your local library to see if they offer a printing service.  Mine does and I've had a few projects like this printed for very nominal cost.

Mike A.