Author Topic: Festool 1400 Depth Stop Movement  (Read 1791 times)

0 Members and 1 Guest are viewing this topic.

Offline mvish86

  • Posts: 1
Festool 1400 Depth Stop Movement
« on: April 15, 2019, 01:16 PM »
Hey folks, looked around and maybe I couldn't find the topic in search but was hoping for some advice.

I set the depth on my 1400 to be fantastically tiny, because I'm trying to erode a thin layer off my plywood so I can glue on some laminate (to create a slippery surface that is perfectly level with the rest of the plywood sheet: think half covered, half not). I've noticed after I set the depth, there's random low spots and high spots and as far as I can tell, all the screws are quite tight. Any advice folks can give me? I've never adjusted the turrets.

My conclusions: Plywood is plywood, not level -- Fair statement, but I should expect to see only subtle variations, not large (1/16 & 1/32 vs 1/64?) OR Something's up with my router and I'm not able to figure it out =(

Finally, I bought the infinity tools 1.5" planer/dado bit, but it's way too big for the existing dust cover - any aftermarket ideas? I'm using the world's smallest bit right now and it's taking forever.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Birdhunter

  • Posts: 2649
  • Woodworker, Sportsman, Retired
Re: Festool 1400 Depth Stop Movement
« Reply #1 on: April 15, 2019, 03:23 PM »
Sounds like a job for a power planer.
Birdhunter

Offline harry_

  • Posts: 1285
Re: Festool 1400 Depth Stop Movement
« Reply #2 on: April 15, 2019, 06:55 PM »
maybe you should try it on a rail, a smoother surface to run on?
Disclaimer: This post is for educational and entertainment purposes only. Any resemblance to real persons, living or dead is purely coincidental. Void where prohibited. Some assembly required. Batteries not included. Contents may settle during shipment. Use only as directed. No other warranty expressed or implied. This is not an offer to sell securities. May be too intense for some viewers. No user-serviceable parts inside. Subject to change without notice. One size fits all (very poorly).