Author Topic: Plugging a festool domino hole  (Read 1552 times)

0 Members and 1 Guest are viewing this topic.

Offline sriram

  • Posts: 1
Plugging a festool domino hole
« on: April 23, 2019, 09:10 PM »
I made an error (mid panel joint) and have a domino hole that I need to plug. The wood is walnut, so I have to match it with whatever I'm going to use to plug the hole. The depth is only 12 mm.

I assume this mistake has been made before. Any recommendations/ideas on how to fill?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tjbnwi

  • Posts: 6066
  • Cedar Tucky Indiana
Re: Plugging a festool domino hole
« Reply #1 on: April 23, 2019, 09:20 PM »