Author Topic: How to make Offset Holes in an existing MFT table top?  (Read 1189 times)

0 Members and 1 Guest are viewing this topic.

Offline WilliamT

  • Posts: 3
Hello everybody,

I am sorry for my poor englisch, I’m german ;-)

Is there an easy way to ad some offset holes to an existing MFT table top?
There is a video Peter Parfitt is telling how to do while making a new table top with the Parf Guide System.
I own the MK2 System and have at this time no need for a new table top, but would really like to have some extra holes for cutting.

Thanks, William

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Jiggy Joiner

  • Posts: 705
Re: How to make Offset Holes in an existing MFT table top?
« Reply #1 on: May 23, 2019, 03:51 PM »
Hi and welcome.
I’ve added extra holes to my tops using the PGS Mk 2.

I made my holes on both edges at 48mm offset. There’s lots of ways of marking them out but, the squaring using both of the supplied rules, is in my opinion the best way.
My holes are parallel to the existing holes but, with offset centres.

Offline WilliamT

  • Posts: 3
Re: How to make Offset Holes in an existing MFT table top?
« Reply #2 on: May 23, 2019, 04:38 PM »
Thanks for the quick reply.
How do you align the rulers with the existing holes to guarantee the offset ones a still square?