Author Topic: MFT/3 with Incra Fence and Shop Stop  (Read 25961 times)

0 Members and 1 Guest are viewing this topic.

Offline rst

  • Posts: 2250
Re: MFT/3 with Incra Fence and Shop Stop
« Reply #30 on: May 14, 2019, 06:22 AM »
Micheal is mostly correct...table saw and router table.  I used a 45% router bit to create the V with shoulders.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline whatskenbuilding

  • Posts: 9
Re: MFT/3 with Incra Fence and Shop Stop
« Reply #31 on: May 14, 2019, 07:54 PM »
@rst  Thanks!

Offline Bugsysiegals

  • Posts: 269
Re: MFT/3 with Incra Fence and Shop Stop
« Reply #32 on: June 06, 2019, 12:02 PM »
I have a 52" Incra fence and multiple stops that are attached to my MFT with UHMW brackets so that it sits off the table.  I can crosscut 27-28 1/2".  I have Woodpeckers MFT square to insure that my rail is square.    (Attachment Link)      
(Attachment Link) (Attachment Link)

I've bought the Shop Stop and would like to mount it similarly for maximum width so thanks for sharing your solution.