Author Topic: T18 guts  (Read 4164 times)

0 Members and 1 Guest are viewing this topic.

Offline ach_78

  • Posts: 47
T18 guts
« on: February 15, 2018, 05:28 PM »
Not a review but some « in » sight.

Bottom line : it is a sleek looking design. Apart from the rotating torque setting there appear to be no mechanical switch. Trigger, reverse and drill position switches are all hall sensors. The torque setting switch is, BTW, very easy to replace if need be. It’s about 20€ over here.

The PCB is fully potted. Motor wires are soldered. I think there is very little chance for malfunction as long as the components themselves don’t fail.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline Lbob131

  • Posts: 469
Re: T18 guts
« Reply #2 on: February 25, 2018, 06:35 AM »
Looks nice.