Author Topic: Kapex and blades  (Read 630 times)

0 Members and 1 Guest are viewing this topic.

Offline alice

  • Posts: 109
Kapex and blades
« on: August 28, 2018, 12:10 PM »
I was just wondering if anyone thinks a thin kerf blade would put less stress on kapex motor over standard blade plus compromise quality of cut? Didn’t know were to post this.
« Last Edit: August 28, 2018, 12:16 PM by alice »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline IndyMike

  • Posts: 112
Re: Kapex and blades
« Reply #1 on: August 28, 2018, 01:37 PM »
A thinner kerf would be removing less material so it would put less load on the motor, sure.

Would it affect dust collection? I don't think so.

Would it affect the quality of the cut? I suppose that depends on whether the blade bends or deflects as a result of being thinner.

I'm sure others with more knowledge than me will chime in.