Author Topic: OF1010 Cutter & collet removal  (Read 258 times)

0 Members and 1 Guest are viewing this topic.

Offline Tom Ward

  • Posts: 1
OF1010 Cutter & collet removal
« on: April 29, 2019, 03:41 PM »
Good Evening,
I am interested to know if anyone has any good tips on how to easily remove the cutter and collet from the drive shaft?  I never over tighten when I assemble the router but always have a struggle to remove and often end up damaging the the router bits when I try and remove them.

Many thanks,

Tom

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.