Author Topic: The Dutchman Again (still not the song)  (Read 1656 times)

0 Members and 1 Guest are viewing this topic.

Offline tjbnwi

  • Posts: 6139
  • Cedar Tucky Indiana
The Dutchman Again (still not the song)
« on: August 30, 2016, 10:02 AM »
"The drop slot you cut in the top, you need to move it" [eek] [eek] [eek]

Need to move the slot form existing location to where the red tape is. 250174-0


Job for the MFS. Using the corner filets created by FOG member Roseland and shipped through Shapeways. 250176-1


Clamped and registration blocks incase I have to reset the MFS.250178-2


1" and 1/2" bushings for the 2200, using 1/4" spiral down cut bit. 250180-3


Removed 1/2" material depth (1 layer)250182-4


ATG to retain the 'Dutchman". 250184-5


2200 set up with 1/2" bushing. 250188-6


I decreased the size of the MFS 1 mm each direction. Need adhesive squeeze in the seam to make this work. 250186-7

"Dutchman" dry fitted. 250190-8


Done. 250192-9250194-10


I used the MFS to make the slot at the rear of the counter. The MFS will not fit with the counter in place. Had to use hot melt glue to hold the 1/2" plywood template in place. A 3/4" bushing with 1/2" down cut serial bit was used to machine the slot. 250196-11250198-12

Tom
« Last Edit: August 30, 2016, 10:11 AM by tjbnwi »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline bkharman

  • Posts: 1998
Re: The Dutchman Again (still not the song)
« Reply #1 on: August 30, 2016, 11:44 AM »
Nice work Tom!

it is pretty cool how that disappeared into the solid surface after setting it.

Thanks for sharing...

Cheers.  Bryan.
People, I just want to say, you know, can we all get along? Can we get along?

Offline Roseland

  • Posts: 628
Re: The Dutchman Again (still not the song)
« Reply #2 on: August 30, 2016, 11:52 AM »
I'm glad it worked well.

If Festool had them injection moulded they'd be more accurate and cost next to nothing; it would be a nice addition to the kit of accessories you get with the MFS-400 and MFS-700.

Andrew
TS55, MFT/3, OF1400, OF1010, CT26, RS100, ETS125, CXS, MFS400, DF-500, Zobos.