Author Topic: Where can I get 80/20 in Australia?  (Read 753 times)

0 Members and 1 Guest are viewing this topic.

Offline Gedhols

  • Posts: 4
Where can I get 80/20 in Australia?
« on: October 08, 2018, 04:31 AM »
I’m building a new workbench and it would be good to have 80/20 around the outside to allow festoon clamps to work...

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline rvieceli

  • Posts: 1044
Re: Where can I get 80/20 in Australia?
« Reply #1 on: October 08, 2018, 06:57 AM »

It will probably be easier for you to source Bosch Rexroth profiles for your project.

click assembly technology from the home page, then aluminum profiles.


Offline jasen

  • Posts: 41
Re: Where can I get 80/20 in Australia?
« Reply #2 on: October 08, 2018, 08:51 AM »
Depending where you are located, theres a number of places. The best places typically sell in 6m lengths but will cut as desired. has distributors.

Another option is Misumi if you have an ABN.

I recently bought off an ebay guy for 2040 extrusion and was happy with purchase.

Offline Gedhols

  • Posts: 4
Re: Where can I get 80/20 in Australia?
« Reply #3 on: October 08, 2018, 05:46 PM »
Many thanks Ron and Jason.... will investigate