Author Topic: Upgrading from T15 to T18. Keep old drill accessories or use new ones?  (Read 441 times)

0 Members and 1 Guest are viewing this topic.

Offline Aniline_Kohlrabi

  • Posts: 4
Hello All,

I bought the T15 drill in 2011 and upgraded to the T18 recently.

I noticed the right angle chuck has been updated with some kind of ceramic coating, but the locking ring is now a co-molded ABS/Metal hybrid. Has anyone noticed performance changes with this accessory vs the older model, which had all metal exterior? On the other hand, the offset chuck and centrotec chuck look the same.

Thanks,
-A

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline Jim_in_PA

  • Posts: 74
I have three different Festool D/Ds...the T12, the T15 and the CSX. All the old accessories work just fine on the newer tools...and I prefer them because they are beefier as you indicate. I do use the lighter weight "new" right angle on the CSX because it preserves the balance better, however. Having multiples hasn't been a problem either sometimes because it allows for having more than one configuration for a job right at hand, even when both need right-angle or both need the traditional chuck, etc., because of what's being done with them.
----
ETS 150/3, Rotex 150, OF1010, OF1400, Trion PS 300, TDK-12, CT-22, MFT 1080, TS55, Domino XL DF 700, 8' track, (2) 55" tracks

SCM MiniMax S315WS, FS350, MM16, Camaster Stinger II SR-44 CNC