Author Topic: Domino support bracket  (Read 2559 times)

0 Members and 1 Guest are viewing this topic.

Offline polarsea1

  • Posts: 294
Domino support bracket
« on: March 14, 2009, 01:24 AM »
I'd like to see Festool make a machined aluminum replacement for the plastic support bracket, a little longer with a knob would be even better.  I'd buy one as an accessory.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline John2532

  • Retailer
  • *
  • Posts: 89
Re: Domino support bracket
« Reply #1 on: March 17, 2009, 12:10 PM »
I agree the support bracket leaves a little to be desired. (bolts on the bottom of the domino)
Machining a new one out of a block of aluminum wouldn't be difficult but would entail a lot of waste. How about starting with a short piece of 4" aluminum angle iron? With just a few holes you should be in business. Or do you think using MDF would be a viable option? 2 pieces with appropriate bracing might work. It would be a little heavy but might actually help balance everything when it is in use.

Offline polarsea1

  • Posts: 294
Re: Domino support bracket
« Reply #2 on: March 18, 2009, 02:01 AM »
Thanks John, I found an online dealer that will sell aluminum angle by the foot. I'm going to buy a foot of 4x4x1/4" angle and give it a try. If it works I won't be trying to balance the Domino ontop the edge of a piece of plywood but will lay the panel flat and plunge vertically. A 4" angle will also give me room to put some sort of knob on it.