Author Topic: Finishing MDO  (Read 1331 times)

0 Members and 1 Guest are viewing this topic.

Offline Twoodman66

  • Posts: 96
Finishing MDO
« on: May 30, 2018, 06:39 AM »
We are using mdo for the first time. Planning on using Sherwin
Surfacer and Kem Aqua +
Should we spray seal coat first?
How should we start?

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline tjbnwi

  • Posts: 6065
  • Cedar Tucky Indiana
Re: Finishing MDO
« Reply #1 on: May 30, 2018, 08:37 AM »
Inspect it for flat, correct as needed, spray away. Same process as plywood or MDF. The show surface is just MDF.

KA+ is my primary finish.

Speaking which, I need to order 30 more sheets.

« Last Edit: May 30, 2018, 08:40 AM by tjbnwi »