Author Topic: Knot Hole and Food Safe Finish  (Read 1138 times)

0 Members and 1 Guest are viewing this topic.

Offline SoonerFan

  • Posts: 437
Knot Hole and Food Safe Finish
« on: February 27, 2019, 09:17 PM »
I don’t do much work that requires food safe finish.  The couple times I have previously I used “Salad Bowl Finish” that I picked up at a local Woodcraft.  It was easy to use and the cutting boards seems easy to clean.  I have a nice piece of black walnut (250mm X 850mm) and have been asked to make a charcuterie tray out of it.  I am planning to use the left over Salad Bowl Finish.  However the walnut has a knot hole I’d like to fill before finishing as I think this will make it easy to clean with the Knot hole filled in.

Any suggestions on how to best fill the knot hole in a food safe manner?  I thought about filling the knot hole with the Salad Bowl Finish.  Reasons being, I have that available and because when cured I know is food safe. I am in no big hurry so if it takes even a week or more to fully harden/cure that is not an issue.

I have read conflicting stories on epoxy as a food safe option and just not sure the best approach.  Thought I would seek some advice on FOG. Thanks in advance.
« Last Edit: February 27, 2019, 09:46 PM by SoonerFan »

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline travisj

  • Posts: 363
Re: Knot Hole and Food Safe Finish
« Reply #1 on: March 08, 2019, 08:39 PM »
I have zero experience with either epoxy or food safe finishes, but since nobody else has answered, I will give my opinion.  I would reach out to the manufacturers of the epoxy and ask them about the food safety part.  I was once told that any type of finish that hardens, once hard is food safe.  I have never tested the theory due to no need for my projects.

Another option would be to check with Woodcraft or Rockler if you have one in your area.  Or better yet, reach out to the local woodworking guild.  In either case, I am sure they have come across the situation before and would be able to give you options.

Sent from my iPhone using Tapatalk

Offline Farming_Sawyer

  • Posts: 124
  • Sawyer, builder, winemaker, farmer, chef
    • Foley's Custom Sawmill
Re: Knot Hole and Food Safe Finish
« Reply #2 on: March 10, 2019, 09:24 AM »
The only way to effectively make the knot hole food safe is to remove it.... Route it out and put a patch in.
CT 26E, RO125, sys-mft, sys-toolbox, a bunch of 30 year old tools I'm looking to replace.