Author Topic: Bevel Gauges  (Read 40289 times)

0 Members and 1 Guest are viewing this topic.

Offline SRSemenza

  • Global Moderator
  • *
  • Posts: 8886
  • Finger Lakes Region, NY State , USA
Re: Bevel Gauges
« Reply #60 on: June 16, 2012, 11:23 PM »
Seth, what length did you get? Eric

Both. Small one (7") will go in the site kit, long (12") will live in the shop. 


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


  • Guest
Re: Bevel Gauges
« Reply #61 on: June 16, 2012, 11:30 PM »
That is a really nice gauge. Im very on the fence about the Woodpeckers bc of the price. I have been so impressed with there stuff though. Totally the type of tool i would get after signing a big kitchen contract, Eric

Offline RonWen

  • Retailer
  • *
  • Posts: 1701
    • Ordering
Re: Bevel Gauges
« Reply #62 on: July 21, 2012, 05:12 PM »
I've been working on a project that requires several angle settings so I've been using the new Woodpecker sliding bevel as well as a couple of others.   I'm finding the sliding "Tee" knob somewhat annoying -- it seems to slide into my way most of the time and/or be at an awkward position for locking the square, I would much prefer just a knurled knob for locking the square. 

I hate to take more points away but when using this square with my BCT Angle Master Pro the non-magnetic stainless blade looses points -- it's much easier setting my Veritas sliding bevel because it snaps right onto the AMP & allows for one hand locking of the thumb lever.
Normally the non-magnetic stainless would be a plus but not with the Angle Master Pro.
Just some observations while I'm working.,42936,50298,43508&pb=1#pb