Author Topic: [Project 13] Finding a good use for the Boom Arm Stabilizer Bars  (Read 1264 times)

0 Members and 1 Guest are viewing this topic.

Offline mattbyington

  • Posts: 334
If you remember during my Project 12 post my boom arm fell over and took my TS 55 with it. I had to send it in for repairs and lost 2 weeks!

Never again. Today, I solved 2 problems with one build:

1) Finding a good use for the stabilizer arms to the boom arm that nobody uses
2) Making sure my vacuum doesn't fall over again

Also, I bought the Carvex Jigsaw and had to make at least one circle (or semicircle) to test it out with. It was my first time using a Jigsaw. Harder than it looks hitting the line spot on...


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline jobsworth

  • Posts: 5790
  • Festool Baby.....
Re: [Project 13] Finding a good use for the Boom Arm Stabilizer Bars
« Reply #1 on: October 15, 2018, 09:48 PM »
thats the ticket loks like you solved that problem buddy  8)