Author Topic: Has anyone adapted the Kreg miter saw fence system for use on a mobile stand?  (Read 457 times)

0 Members and 1 Guest are viewing this topic.

Offline Alanbach

  • Posts: 392
I own a delta miter saw cart which works really well for me in my shop. I can make short cuts in the place where I keep it or if I need to make longer cuts I just open my garage door and roll it out onto the driveway. I would really like to utilize the Kreg miter saw fence system that I bought a few years ago but I don’t want to make a permanent station for the saw as I like the cart. Has anyone adapted the Kreg system to use on a cart? I want the fences for repeatability. I am sure that I can work out a way to make the wings mount and unmount easily but if someone here has already done it I would love to see and hear about it. TIA

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.


Offline gnlman

  • Posts: 202
@Alanbach

Hi. If you haven't already, check out YouTube. I saw some really neat ideas from folks that did just what you are explaining. sorry didn't keep track of them, but came across them when I was researching mitre saw stations. I have Kreg system too, having a bit of issues with the flip stop...it does not seem to fit snugly in the track, and will move a bit when tightened down. I may have assembled it marginally....I'll have to look at it again....simply putting some pressure on it as you tighten it seems to work fine.
greg