Author Topic: Incra LS positioner super system question  (Read 775 times)

0 Members and 1 Guest are viewing this topic.

Offline AndrewG

  • Posts: 104
Incra LS positioner super system question
« on: April 24, 2019, 08:16 PM »
Hi all,

I’ve been looking to upgrade my router table for some time now and finally came across a good deal on a Incra LS positioner super system (17”).

I’m quite new to this system and haven’t even picked it up yet, but as you do I’m trying to learn and educate myself how to properly use it.

First up, I’d like to mount it on my table saw extension table pictured below. It’s currently 900mm long, but I plan to replace it and could potentially go to 1000mm or longer. Now, the instructions say it needs to be mounted 17” from the centre of the router (I’ll also buy the incra insert plate).

Now, this will mean it will get in the way if I need to rip anything that is as wide as where the positioner is mounted. My question is, what methods have you come up with to accurately remove and put back on the LS system?

The FAQ section on the incra site states, “The oval top section of the positioner's base can be removed from the T-slotted sub base. This oval section can then be attached to a piece of good-quality 3/4" plywood and then mounted in a variety of ways. A wooden router table encourages using knobs through the plywood threaded into T-nuts inserted into the underside of the router table.”

Has anyone done this and could post pictures? Or has someone come up with another way. I’d really appreciate the replies.


Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.

Offline infer

  • Posts: 66
Re: Incra LS positioner super system question
« Reply #1 on: April 24, 2019, 11:54 PM »
I used a small piece of MFT’s extrusion on the end of my custom mft bench. I can now move the LS from the CMS to the bench just using a kapex crown stop. Just need to shim the extrusion so it’s square to your bench.

Offline infer

  • Posts: 66
Re: Incra LS positioner super system question
« Reply #2 on: April 27, 2019, 10:32 AM »