Author Topic: Fusion 360 For Woodworkers Course on Udemy - ON SALE!  (Read 6281 times)

0 Members and 1 Guest are viewing this topic.

Offline Dick Mahany

  • Posts: 500
Re: Fusion 360 For Woodworkers Course on Udemy - ON SALE!
« Reply #30 on: September 15, 2018, 08:04 PM »
I started watching the course, then tried to do the same things using Fusion 360.  Crashed every time I tried to add a rectangle.   Did some web searching, turns out that my old iMac (2007) only has 256MB of VRAM.  Apparently Fusion 360 requires at least 512MB of VRAM.  Would have been nice if the software checked this when installing.

Have to find a different computer.....

Even on a relatively new (2yrs old) MS Surface Pro, I get a message that my graphics card may be sub optimal.  Fusion 360 is definitely more resource intensive than Sketchup, but for good reason.....power.

Festool USA does not pre-approve the contents of this website nor endorse the application or use of any Festool product in any way other than in the manner described in the Festool Instruction Manual. To reduce the risk of serious injury and/or damage to your Festool product, always read, understand and follow all warnings and instructions in your Festool product's Instruction Manual. Although Festool strives for accuracy in the website material, the website may contain inaccuracies. Festool makes no representations about the accuracy, reliability, completeness or timeliness of the material on this website or about the results to be obtained from using the website. Festool and its affiliates cannot be responsible for improper postings or your reliance on the website's material. Your use of any material contained on this website is entirely at your own risk. The content contained on this site is provided for informational purposes only and does not constitute professional advice.