90 Degree Jig for the Festool Guide Rails

[cortes]

Is there a Festool or aftermarket jig to slide into a guide rail so you can square it to the edge of the piece to be cut? I can probably make one of my own, but I wanted to check if there wasn't already one out there. It's really not a lot work to put a square up to the edge of a guide rail to square the cut. I'm always looking for an easier way.

 

[rvieceli]

Here you go:

http://www.qwasproducts.com/QwasSquare.html

http://www.bobmarinosbesttools.com/product.asp?pn=QDGS

 

[Holmz]

Or with a 3mm allen key and 2 dogs, then you can square the rail to the Dogs. (or parallel the rial to the dogs).

 

[ear3]

Haven't used either of these, but just so you know they exist:

http://festoolownersgroup.com/festool-tools-accessories/triton-t-square-attachment/msg398035/#msg398035

http://festoolusa.com/power-tool-accessories/guide-rails/kits-and-other-accessories/angle-unit-491588

Also, not sure if you're familiar with the razor blade method of positioning the guide rail, but it works fantastically (just make sure your splinterguard isn't degraded).  It was one of the first things I learned about when I came to the FOG:

http://festoolownersgroup.com/festool-tools-accessories/razor-blades-and-guide-rails/msg27568/#msg27568

 

[Kev]

I like this ...

http://www.festool.com.au/epages/tooltechnic.sf/en_AU/?ObjectPath=/Shops/tooltechnic/Products/768168

 

[ear3]

I think that's NAINA.

I like this ...

http://www.festool.com.au/epages/tooltechnic.sf/en_AU/?ObjectPath=/Shops/tooltechnic/Products/768168

 

[Kev]

I think that's NAINA.

I like this ...

http://www.festool.com.au/epages/tooltechnic.sf/en_AU/?ObjectPath=/Shops/tooltechnic/Products/768168

Sorry [embarassed]

 

[Flynnworx]

Clamp speed square to track with festool clamp in track

 

[cortes]

Wow, several choices. Thanks for all the replies.

 

[Brent Taylor]

A piece of plywood, a pair of water closet bolts,fender washers and wing nuts has worked well for me.  I always have the hardware with me and the ply is easy to find.

 

[Holmz]

I used my bosch one the other day.
http://justtools.com.au/bosch-mitre-segment-for-fsn-guide-rails-gkt55gce-fsnwan

I am considering whether I need the miter on the MFT now...?