Anybody else with eccentric chuck drive their pocket holes like this?

[ear3]

I occasionally get frustrated with pocket screws -- especially ones sunk in thick material -- by how the bit will stop engaging the screw head as the screw goes deeper and the drill chuck forces the machine to angle away as it contacts the wood.  A small lightbulb went off in my head this weekend, and I realized I could use the eccentric chuck on my T18 to keep the drill at the optimum angle most of the way through the drive. 

 

[bobfog]

I just used a 6" torx bit and the problem doesn't come up.

 

[Tinker]

I just used a 6" torx bit and the problem doesn't come up.

Same here. 
Tinker

 

[GarryMartin]

Same here, 150mm Kreg bit although interesting point about the offset chuck for use in cramped conditions where the 150mm may make the overall bit/drill length too long. Had this with some noggin installs between floor joists where plumbing presented some interesting space challenges!