So there's a guy not far from where I live that's trying to get rid of some old machines used to produce furniture. All the machines seem to be very big industrial specialty machines, and the only one I'm remotely interested in is an old spindle moulder. I am only a beginner/hobbyist, and have a very limited space and budget. I've never even used a spindle moulder before, but I think I could see myself using it some (?). So if I get this machine for next to nothing - should I buy it (it's gone cost me some money + time and money to transport it)? I was thinking that a worst-case scenario is scraping it, and keeping the motor and cast iron table.
Buy big spindle moulder for next to nothing with VERY limited shop space?
- Thread starter Ingebrigt
- Start date
Birdhunter
Member
- Joined
- Jun 16, 2012
- Messages
- 4,144
I also have limited shop space and a huge machine like what the picture shows would use much more space than my usage would justify. I've been a serious hobby woodworker for over 30 years and have never needed a machine like that.
Ingebrigt said:
Thats what I was thinking when I mentioned salvageing the cast iron table and motor. I don't even have a router table now, but I bet it's gone be hard getting this to fit.
Peter_C said:
I will have three phase when the wireing in my shop is done (3 phase 230v 25a)
Birdhunter said:
That's exactly what I'm thinking to, when being reasonable. But I like being unreasonable too much. So i posted this here hoping you guys could talk some sense into me (or was it the other way around? I'm not sure...)
Birdhunter
Member
- Joined
- Jun 16, 2012
- Messages
- 4,144
Common sense = do not buy this machine.
WarnerConstCo.
Member
- Joined
- Apr 14, 2008
- Messages
- 4,205
What are the rest? Just put them in a container for me.
Kev
Member
- Joined
- Nov 7, 2011
- Messages
- 7,698
These big old machines need a lot of respect .. they were typically built to last forever, with pretty much everything that could wear out being replaceable or rebuildable.
A large spindle moulder wouldn't take up a lot more space than a decent router table, but the puppy you're looking at won't be something you'll be moving about - so your location of choice would have to have all the access you need!
You need a bit of engineering skill if you get something like this and it needs some work .. and if you have that and a passion for this stuff ( like [member=3891]WarnerConstCo.[/member] ) you'll probably love it!
If you don't have the patience to refurbish and/or maintain it .. walk away [wink]
A large spindle moulder wouldn't take up a lot more space than a decent router table, but the puppy you're looking at won't be something you'll be moving about - so your location of choice would have to have all the access you need!
You need a bit of engineering skill if you get something like this and it needs some work .. and if you have that and a passion for this stuff ( like [member=3891]WarnerConstCo.[/member] ) you'll probably love it!
If you don't have the patience to refurbish and/or maintain it .. walk away [wink]
Festoolfootstool said:
It's not in the US, it's in Norway. Theres very few machines like this around here, and very long distances. This is only a couple of hours drive away + two ferries, so it's quite close.
I'm waiting on some more pictures of the machine, and information about it, and what bits/irons (?) I will get with it. I don't have much engineering skills, but that's something I want to learn (recently changed a wheel bearing, rotors etc on my car for the same reason).
