clamping

[mig2993]

Any information on the clamping system?Where to buy cost?

 

[dltflt]

If you want the clamps to fit your rail I would recommend the  Festool 491594 Quick Clamps or the 489570 Screw Clamp. Both are very good and will fit the track saw rail and the MFT/3.

 

[jbasen]

Dewalt also makes a very nice set of clamps that will work with the Festool Guide Rails.  Their advantage is that they can be operated 1 handed. 

However, be aware that they cannot be used to secure work pieces to the top of an MFT like the Festool Clamps.  The design doesn't allow you to thread the clamp down through one of the holes in the top of the MFT.

Here is a link

http://www.amazon.com/DEWALT-DWS5026-TrackSaw-Track-Clamps/dp/B001J31PJM/

Jay

 

[semenza]

Any information on the clamping system?Where to buy cost?

Hi,

Welcome to the FOG!  [smile]

I am betting you are referring  to the vacuum clamping system. A term that you will see frequently on this forum is NAINA ......... Not Available In North America.

Seth

 

[mig2993]

Any information on the clamping system?Where to buy cost?

Hi,

Welcome to the FOG!  [smile]

I am betting you are referring   to the vacuum clamping system. A term that you will see frequently on this forum is NAINA ......... Not Available In North America.

Seth

Yes ,I was Seth. thanks for the info