I bought a 2nd hand CS70 a while back and must confess its the Festool I like the least.
Its dust collection is iffy and the fence is a pain in the butt to use with the extension table on.
Was seriously thinking about selling it and getting a Jet Prosaw with the Incra TS-LS tablesaw fence. This would have cost me a packet.
Then got a brainwave [eek]
Why not put the CS70 right next to the MFT, connect them in one or other way and fit a Incra LS 25" on top of the MFT.
In this way I can rip quite wide using the MFT as a support table and by lowering the blade on the CS I am extending my worksurface for the MFT.
Any comments appreciated.
Its dust collection is iffy and the fence is a pain in the butt to use with the extension table on.
Was seriously thinking about selling it and getting a Jet Prosaw with the Incra TS-LS tablesaw fence. This would have cost me a packet.
Then got a brainwave [eek]
Why not put the CS70 right next to the MFT, connect them in one or other way and fit a Incra LS 25" on top of the MFT.
In this way I can rip quite wide using the MFT as a support table and by lowering the blade on the CS I am extending my worksurface for the MFT.
Any comments appreciated.