When doing multiples (54 Drawers, that's 216 parts, that's....about 1300 plunges)
[attachimg=1]
The Cross Stops need to be checked constantly or they loosen up and fall off. I started to tighten them up by rotating the internal cam, but that's hard on the plastic. Now I replace the small internal cam every once and a while and that keeps them going. I think they cost a dime each when i bought 20 from festool parts.
This drawer session I came up with a new fix with stretchy 3m tape.
Too bad there is not a robust alternative like the Domi-plate. I've seen the woodpeckers but it is a little overcomplicated, expensive and not available.
Just thought I'd share my simple fix.
[attachimg=1]
The Cross Stops need to be checked constantly or they loosen up and fall off. I started to tighten them up by rotating the internal cam, but that's hard on the plastic. Now I replace the small internal cam every once and a while and that keeps them going. I think they cost a dime each when i bought 20 from festool parts.
This drawer session I came up with a new fix with stretchy 3m tape.
Too bad there is not a robust alternative like the Domi-plate. I've seen the woodpeckers but it is a little overcomplicated, expensive and not available.
Just thought I'd share my simple fix.
