HI there -
I recently bought a Conturo and the accessories kit. So far i really like it for applying 2mm edge banding. One area i am struggling with is the trimming of the edge banding flush with the end of a panel where there is a inside corner (ie the front of a cabinet where the banding rides past the toe kick or on a top/bottom end where it is set up for a blind dado).
The Festool cutter is fast and works really well on outside 90 cuts but beacuse it rests on the side (not the front) of these pieces it wont work on them.
Does anyone know if there is there another manufacturer or another festool tool i am missing that will register against thr front of the work pieces and cut the side ie opposite of the festool cutter in the kit?
Thanks!!
I recently bought a Conturo and the accessories kit. So far i really like it for applying 2mm edge banding. One area i am struggling with is the trimming of the edge banding flush with the end of a panel where there is a inside corner (ie the front of a cabinet where the banding rides past the toe kick or on a top/bottom end where it is set up for a blind dado).
The Festool cutter is fast and works really well on outside 90 cuts but beacuse it rests on the side (not the front) of these pieces it wont work on them.
Does anyone know if there is there another manufacturer or another festool tool i am missing that will register against thr front of the work pieces and cut the side ie opposite of the festool cutter in the kit?
Thanks!!
