Festool DX 93

Status
Not open for further replies.

nickao

Member
Joined
Feb 24, 2008
Messages
4,617
Festool DX 93

Used one time to test it.

265.00  including shipping.

For an ADDITIONAL systainer with sandpaper and foam to hold the sander in the systainer for 295.00.

I may change my mind if it does not sell before Christmas.

Guaranteed to work and 30 day 100% refund including shipping back as long as it is in the same condition.

I hate selling Festool's.  :'(

 
I have to change this. I can not find the original systainer for this. I have it somewhere in my workshop which is a shambles and a disgrace right now. The second SYS with the sandpaper is hiding along with it. I was just looking at the stuff a week ago and can'lt find them!

Anyway,  I can put it in a sys2 with some foam for 250.00 and toss in a new Festool pigtail for you to change on your end.

If you do not want the SYS2 I would sell just the sander alone for 210.00.

I did notice even though I only tested this on one project for about 15 minutes there is a slight scratch on the pad(and I mean slight) in the corner. I am sure this would happen with any brand new one as well. I had no mishap.

 
nickao said:
I am sure this would happen with any brand new one as well. I had no mishap.

This is correct. The Festool pads deteriorate alarmingly quick. I had to put a new pad on my brand new DX93 after only 2 weeks. I did give it some heavy use, but under the same circumstances my Metabo held out for over 3 years. I recently bought a new pad for the DS400 because the tip was totally worn, and guess what? After 5 minutes of use the new tip looked almost like the old one.
 
Thanks for the verification as I was surprised going back over it that it looked the way it did after such limited use.  :)

Still, I am quite picky and on this unit the way it is now probably would be missed by most people. Selling stuff I found it is better to mention every little thing.
 
Status
Not open for further replies.
Back
Top