Halloween router bowls
- Thread starter Stoli
- Start date
copcarcollector
Member
- Joined
- Jan 11, 2013
- Messages
- 1,455
Very cool! Did you use the patterns from Eagle America/MLCS?
The template is from Peachtree. I was able to see the actual template through amazon, and made sure it had the outline for the pointy parts of the wings. I think all the other ones are the same (at least the pictures of the bowls are the same), but can't be certain.
copcarcollector
Member
- Joined
- Jan 11, 2013
- Messages
- 1,455
Thanks! There is a large selection of various bowl templates, I have been tempted to just buy them all. Nice to see the final result.
copcarcollector said:
At ~$20 each, you'd quickly get to the point where it may be cheaper to get a starter CNC (like a shapeoko). I went for a kit that had the bit, a wide base, and 3 or 4 templates. I think what finally pushed me over the edge was seeing Richard's out of the bowl thinking on how to use the bowl bit for nice inset storage areas.
