Kapex REB question

[Toolpig]

Anybody know if the Multiblades extension wing brackets fit on the new Kapex? The sides of the saw where they would clamp on look different.

 

[FestitaMakool]

Should be ok, as FT’s own wings must fit.
The REB does have less surface for the wings to attach to.
- it annoys me as Festools own UG wings barely touches the rear side of the “V” profile.
I’m looking to improve the contact surface.

 

[Toolpig]

I’m a bit annoyed at a couple of things about this saw (I had the older version, too). The slide out wings aren’t very useful and, to make room for them, they relocated the angle finder to the rear of the saw. Harder to get at and it gets a lot of dust on it. Especially in a workshop where the saw is against a wall, like mine is. I liked the old version better, minus the motor issues.