MFT Table Top

[Qwas]

I'm wondering if anyone knows what the tolerances are for the MDF Top (488 565 and/or 489 396)?

Particularly, the squareness of the corners and the alignment of the holes.

+/- how much.

 

[greg mann]

Perhaps Chrisian would like to comment on the manufacturing technique used to bore the holes. If it is a CNC router, at least one made in Germany, I would suspect something on the order of +/-.05mm (.002") or in our world, perfect.

 

[Qwas]

That's exactly what I suspect they are using.

 

[ericbuggeln]

I don't know if this means anything, but I have three mft table tops purchased at different times, but all within the last twelve months.  I have had them separate but now in a jumbo mft.  One of them was a little thicker and much darker in color.  Was there possibly a change in distributor ?  Would this lead to differences possibly?

 

[mhch]

  I remember I read somewhere in this forum that recently Festool slightly modified the hole diameter,
  and this was confirmed by a Festool representative