Mobile MFT/3 build

[goyya76]

It's a very beautiful bench, and the bike too - i have an old 2003 Jekyll, which is the right complement for my pretty rough, not yet finished table!

New member here...hello all from Italy, Francesco

 

[duc996]

It's a very beautiful bench, and the bike too - i have an old 2003 Jekyll, which is the right complement for my pretty rough, not yet finished table!

New member here...hello all from Italy, Francesco

Hi and welcome Francesco, thank you.

 

[wow]

It's a very beautiful bench, and the bike too - i have an old 2003 Jekyll, which is the right complement for my pretty rough, not yet finished table!

New member here...hello all from Italy, Francesco

[welcome] Francesco!

Be sure to post pictures of your tools and projects when you can. We love to see what other members are doing!

 

[newbirdhunter]

Great job! Do you have plans you want to share?  [tongue]

 

[duc996]

Great job! Do you have plans you want to share?  [tongue]

Francisco, sorry I do not have any plans as I was building on the fly. I just used the measurements from the MFT top including the side extrusion profiles and systainers and adjusted to my preferred working height and built from there.  [smile]

 

[hammer6048]

Not wanting to reinvent the wheel, anyone have plans for one of these?  Thanks

 

[Kettingspanner]

Yes it will fit through a 36" doorway, the overall height with 27 3/8" with the MFT top is 34 5/8". You can also roll with the MFT top in a 36" opening because it is 30 3/8" wide. HTH.

Nice build! How did you came up with the height? I would like to keep the top at 90cm, since the standard Festool workheight it 90cm. So it would be the same height as you kapex on its base, or the Festool sawtable. Perhaps i miscalculated it, but it seems your build is slightly lower?