N4400 Bandsaw Fence Problem

[Prizen]

Hi all

On my new N4400 bandsaw I’ve found that the rip fence supplied is not square to the table.

Anyone know if these are adjustable? I’ve had a look and there is nothing obvious to me apart from somehow shimming it.

Btw, I am not saying a rip fence on the bandsaw is all that useful, but would like this square!!

 

[rvieceli]

I believe that [member=4358]derekcohen[/member] has an N4400. Perhaps he can help you out.

Ron

 

[Prizen]

Thanks Ron, I know Derek from previous posts

 

[derekcohen]

It is possible to adjust the rail for the fence.

Look at the photo below. This is taken from below the fence. You can see the thread/nuts holding the rail. Loosen/adjust/tighten until you get the fence parallel to the mitre slot (the extra rail here is for a Wixey) ...

Regards from Perth

Derek

 

[Prizen]

Thanks Derek, I wasn’t clear in my post, but the angle the face of the Alu fence makes with the cast iron table top is quite a bit less than 90.

I will post a photo